Image shows applied level optimization trim for Left Tweeter
When Expert Assist is performing the Autoset Levels Procedure, the user is given an opportunity to make adjustments to the level output of each channel. If the data does not match up with the Target properly, the user can manually adjust the level of that channel to be positioned properly.
It is important to note, by pressing “OK” the user is accepting that they are happy with the results. This means that if the results are poor, the user accepted it. It is always the user’s responsibility to make sure the results are sufficient.
Expert Assist: Before You Begin
Expert Assist: Setting Up a Target
Expert Assist: Identifying Which Channels to Tune
Expert Assist: Identifying Channels to Leave Unmuted:
Expert Assist: Assigning a Target Response
Expert Assist: Selecting Number of EQ Bands
Expert Assist: Confirming All Microphone(s) Are Connected
Expert Assist: Controlling The Volume
Expert Assist: Autoset EQ to Target
Expert Assist: Making Manual Adjustments for EQ
Expert Assist: Level Setting Procedure
Expert Assist: Making Manual Adjustments for Level <<< You are Here
Expert Assist: Delay Setting Procedure