See what's new at

VXi: DRC-205 & DRC-200 Operation

JL Audio DRC-205 controller

The DRC-205 and DRC-200 are dual concentric control knobs that are optional for the VXi amplifiers. The DRC-205 or DRC-200 connect to the JLID port on the VXi chassis, offering master volume control, preset switching as well as the option for either subwoofer control, zone control, balance or fading abilities.  These options can be found in the Set Up tab under DRC Setup labeled as volume/subwoofer, volume/fader, or Zone 1 & 2 Volume.    

The Inner Knob on the DRC-205 and DRC-200 is used for master volume control and PRESET selection.

The Master Volume is controlled by rotating the Inner Knob (clockwise for louder and counter-clockwise for quieter). Using a master control knob for volume is useful in vehicles that have volume dependent equalization (EQ curve changes with the volume level), where a linear response is desired.

Pressing the Inner Knob of the DRC-205 or DRC-200 for 1 second toggles through the Active Presets stored on the VXi amplifier. The multi-color LED is imbedded in the DRC-205 and attached to the DRC-200 can be installed in the vehicle and will display the color code of the Preset currently selected. Read more about VXi presets.

The Outer Knob of the DRC-205 and DRC-200 can be configured in the TüN™ software to perform the following functions:

Subwoofer Control: In this mode, the Outer Knob of the DRC-205 or DRC-200 will control the level of selected channels, relative to the master volume. The most common use of the feature is for subwoofer control (hence the naming), but it can be used to control the relative level of any selected channels: tweeters, rear fill or a center channel, for example.

Zone Control:  When Zone Control is selected in the TüN™ software, the outer ring of the DRC-205 or DRC-200 becomes a fully independent level control for the selected channels. The level of channels selected to this mode will not be affected by the Master Volume level.

Fader:  The Volume / Fader mode allows you to assign one group of channels to the left side of the Outer Knob's center, and another group of channels to the right side of center. The assignment is done in the TüN™ software. These level controls are relative to one another. At the 12 0'Clock position both sets of channels will play at full level. Rotating the control to one side will attenuate the opposite side's channel(s). At no point will either set of channels exceed the level at the 12 0'Clock position. This is how Fader controls in head units operate. VXi gives you the power to create simple or complex fading behaviors with this tool.


Was this article helpful?
1 out of 1 found this helpful
Have more questions? Submit a request